Application
For interior and exterior use as thin screed/wearing surface
for industrial surfaces.
Suitable for new construction and restoration works, e.g. park garages, industrial halls,
for repair of industrial screeds damaged by rain. After setting water resistant as
well as resistant to frost and de-icer.Technical
Data
Raw material basis
Fast-hardening, almost chromium-free cement combination (acc. to TRGS 613) with high
proportion on mineralic/synthetic hard aggregates (acc. to DIN 1100), corresponding to DIN
18 560, part 1, strength class A, sysntetic-resin modified. At a temperature +18°C the
following values result:
Pot life
Resistance to walking stress
Resistant to fork lift traffic
Compressive strength
Tensile strength
Bond strength
Wear resistance
|
Approx. 30 minutes
Approx. 3 hours
after 3 days
3 days > 3600psi
25 N/mm²
7 days > 4350 psi
30 N/mm²
28 days > 5800psi
40 N/mm²
28 days > 25 N/mm²
28 days > 25 N/mm²
acc. to DIN 52108
< 5.0 cm³/50 cm³ |
Properties
-fork lift resistant
-resistant to gasoline, mineral oil and solvents
-not electrostatically chargeable
-jointless installation
-anti-skid, tough
-de-icer resistant
-available in colours
|
KOROPLAN
PC, depending on the absorption capacity of the subbase, is diluted with
water in a ratio between 1:1 up to 1:3 and is applied by means of brush or squeegee.
Formation of puddles to be avoided. When coating the subbaseshould be
matt-damp. Processing
1 bag KOROPLAN DUR (25kg) to be mixed with
approx. 5 ltr water. The use of a stirrer with approx. 600 rpm is recommended.
After drying out of the primer KOROPLAN is cast and spread over the surface by
means of scraper-toothed spatula. The floor covering is self-leveling, also pumpable
(e.g. Monojst of company PFT) and results in a closed, plane surface without additional
grinding or smoothing. Daily performance per working team up to 2,000 m², in case
of slope KOROPLAN DUR must be modified for higher stability.
Processing temperature min. + 10°C
Consumption 1.7 kg/m² per mm layer thickness
After-treatment
After drying out of the surface we recommend the sealing with KOROFINISH on an
acrylat-basis or the epoxy resin impregnation KOROPOX. This enhances the chemical
resistance and has the effect of rejecting moisture and contamination, leading thus to
dust-free surfaces, which can cleaned easily.
Packaging / Delivery
25 kg special paper packaging
Storage
Dry and protected from heat and direct sunlight. Shelf-life 6 months. Once
opened units must be closed immeadiately. |
Subbase Requirements
Subbase must be resistant to pressure and pull, load bearing, dry and free from
contaminations and other separating agents. It must meet the demands of DIN 18365 as
well as DIN 18560 part 3, para. 4.1. Before processing or one day before, the
subbase must be primed with KOROPLAN PC. |
Remarks
This product contains cement and has an alkaine reaction with humidity/water.
Therefore protect skin and eyes. In case of contact with eyes contact doctor.
Our recommendations for application techniques are based on our experiences. It is
recommended top adapt processing and material quantities according to local conditions and
we refer to our terms of delivery and payment,
Information material, application instructions, tender texts for eh different KORODUR
Industrial systems, KORODUR hard aggregates, KORODUR special material, building-chemical
additives are available on request. |
